Odour is a
chemical problem.

Organic matter, bacteria and ammonia gas each need a different reaction, it's a matter of science.

Close-up of pale, porous mineral rock, its surface pitted with small holes
PETFILL

A natural mineral that intercepts the smell before it starts.

01 / Install

Brushed into the turf

PETFILL is clinoptilolite, a natural mineral from the zeolite family: minerals whose crystals are full of tiny pores. It's brushed into the turf pile during or after installation, and replaces or tops up the standard infill layer.

02 / Absorb

Holds urine in the infill

Those pores let the granules work like a sponge. When urine lands on the turf, they soak it up and hold it in the infill, before it can drain through to the backing and sub-base where it would start to break down.

03 / Trap

Traps the ammonia

As that urine breaks down, it releases ammonium, the source of the ammonia smell. Clinoptilolite's crystal carries a negative charge, so it pulls in the positively charged ammonium and swaps it for mineral ions it already holds. That swap, called ion exchange, locks the ammonium in the pores so it can't escape into the air as ammonia.

04 / Renew

Top up over time

Because it stays in the turf, PETFILL keeps working after every incident rather than needing to be reapplied. Over time its pores fill up with ammonium, and weather and foot traffic wear the granules down, so a top-up brings it back to full strength.

vs standard infill

Why not just use sand?

Standard sand or rubber
  • Urine drains straight through to the backing and sub-base.
  • Ammonia pools underneath, builds up and gasses off.
  • No cooling effect.
  • Cheapest to buy up front.
PETFILL
  • Captures urine at the infill layer.
  • Locks ammonia ions by ion exchange before they gas off.
  • Holds moisture for evaporative cooling.
  • 1 application lasts years.
The cooling test

A cooler surface, measured independently.

The same porous structure that traps ammonia also holds water. When rain, dew or irrigation lands on the turf, that held moisture evaporates and draws heat out of the surface.

Independent testing by Acousto-scan, an accredited lab that has worked for the AFL, Cricket Australia, FIFA and the ITF, measured an average 15°C surface-temperature drop on PETFILL-treated turf once combined with moisture.

15°C
average surface-temperature drop, once combined with moisture
Built for
Synthetic turfNatural lawnKennels & runs
Shop smellBgone PETFILL
Common questions

What people ask before they buy.

Why does the smell come back after I hose the turf?

Water spreads the uric-acid crystals and bacteria around, but it does not remove them. As things dry out, the smell returns. You need to break the crystals down with PLUS+ or kill the bacteria with SYNTURF, not just rinse.

Does an air freshener or scented spray do the same job?

Only until the scent fades. Masking sits one smell on top of another. smellBgone removes the source, so there is nothing left to cover.

Is it safe around pets and kids?

Yes. Everything is non-toxic and made in Australia. Keep pets off while you apply and let the area dry. For PETFILL, wear a dust mask and gloves while brushing it in, as a precaution against loose mineral dust.

How often do I need to reapply?

PLUS+ and SYNTURF are used as needed, incident by incident or as a regular turf sanitise. PETFILL is built into the turf and lasts years from 1 application. Top it up as weather and wear use up its capacity.

Which product do I actually need?

Spot spills and stains indoors or out: PLUS+. Sanitising a whole lawn, run or commercial area: SYNTURF. Stopping turf odour before it starts, from installation: PETFILL. Many people put PETFILL in the turf and keep PLUS+ or SYNTURF on hand for whatever lands on top.